3SGTE Breakbout Board ** CLOSEOUT **

Special price - these were $76.00 for the bare board, I'm now blowing them out to make room for the 3rd generation of boards! New! Wiring up an EMS to your car has never been easier! The 3SGTE breakout box provides a neat, safe way to wire an EMS into your MR2 or Celica without cutting any factory wires. Features:

• Plugs directly into factory wiring
• Brings all relevant leads out to clearly-labeled solder holes (for injectors, sensors, power, ground, etc).
• Configurable by jumpers to work with 1990-1992 USDM MR2 Turbo, 1993+ USDM MR2 Turbo, 1993 JDM MR2 Turbo, 1994-1998 JDM MR2 Turbo and 1994+ JDM ST205 Celica
• Offered in kit form (board + connector + jumpers + options), or as a bare board only for the DIY crowd.
• Fits in any Eurocard-sized (160cm) case. I have a limited number of custom-sized enclosures available.
• Suitable for 20 awg sensor wires and 18 awg high-current (injector, power, ground) wires.

Configure your kit using the drop-down boxes, the default is for the bare pc board only, but you can add a hardware kit (connector, screws and jumpers), your choice of an on-board 3- or 4-bar map sensor, and an extruded aluminum enclosure (blank end plates).